INTAKE TUBE WITH MOLDED IN MAF
The best part of this JLT Big Air is we kicked the cool factor up a notch and molded a 123mm MAF housing right in the tube. This makes a much smoother interior without any transitions, steps or couplers to upset the air flow. Another benefit is the over all look is just plain awesome! Early testing shows this can be used with the stock MAF sensor all the way up to 750 RWHP and well beyond with a MAFia, SCT BA5000 or HPX sensor.
The vacuum formed ABS plastic heat shield blocks engine heat at idle and low speed. It has a weather strip that seals to the hood, and incorporates the fresh air inlet from the grill. It uses a large area to make sure the filter has tons of cool air. Now includes new redesigned heat shield so 2013 GT500's no longer have to move the intercooler pump.(2/25/13)
We use only the best air filters made by S&B to our specifications. We love S&B's tapered flange design and Powerstack filtered ends. With a huge 5” opening on the tube we needed a huge filter. The result is a monster 5x9” filter with built in screen to straighten airflow. It measures a full 8.25” across at the base and 5.5” at the top.
OIL OR DRY
We use only the best air filters made by S&B to our specifications.
For years we only used oiled filters, but dry filter technology has been proven and is now a popular option.
Should I choose a Dry Disposable or Cotton Oiled Filter?
Since you are not sacrificing performance with either choice, the decision comes down to would you rather throw away the filter or clean it.
Dry: Comparable airflow to oiled cotton filters with the same great protection.
Last for up to 30,000 miles of highway driving. Extend the life of the filter using compressed air.
Oil: Oiled filters can last forever as long as you properly clean and re-oil it.
See picture of filters below. Oil filters are available in red or blue and Dry filters are white.
A JLT specific tune is required with this kit.
Standard finish is an OEM looking black textured plastic.
The new design, detailed instructions and online video instructions helps make this an easy install.
- JLT Plastic Intake Tube
- Silicone Coupler
- 5x9 S&B Powerstack Air Filter
- ABS Heat Shield
- HD Clamps & all needed hardware
JLT Pre-Filters are now available for most intake kits we carry, these filters are made for us by Outerwears, these prefilters are water repellent. They will increase your filter life and cut down on your cleaning intervals! For more information check the product page here JLT Air Filter PRE FILTER
To properly clean your oil filter, we recommend the S&B Precision II Cleaning & Oiling Kit.
COMPUTER TUNING IS REQUIRED WITH THIS KIT
|www.realspeedauto.com Ph.631-563-7325 |
All parts listed are for the Ford Mustang unless otherwise noted.
Copyright 2018 Realspeed Automotive Inc. All rights reserved.