Steeda Cold Air 10-12 GT500

With the 2010-2012 GT500 Mustang Ford took this car to a level never seen before at the O.E. level. Just like the 2011+ 5.0L Mustangs, Ford put an outstanding air intake system on these cars giving the customer an extremely high level of performance and capability right from the showroom floor.

We have taken that a step further with our new ProFlow Cold Air Intake for the 2010-12 GT500. Designed, tested, and assembled all in-house. This kit completely replaces the factory intake assembly. This kit is specifically designed to utilize the factory cold air feed from the grille and incorporates a serviceable high flow air filter, an injection molded velocity stack, black powdercoated heat shield, and our high flow ProFlow intake tube.

With a large 114mm mass air flow pipe we achieved a substantial increase in air flow at all engine rpm's, not just at redline. The heat shield seals to the hood liner and also keeps the factory cold air feed duct keep out all hot engine bay air for maximum power.

This GT500 cold air intake is so effective at improving airflow into the 5.4L supercharged engine that a performance tune is required for maximum performance and driveability. This intake will not work with the factory ECU calibration.

Power gains are achieved over the entire RPM range. More power and improved throttle response is available everywhere at any time when you need it.

Our easy to install kit comes with premium hardware, silicone sleeves, and installation instructions.

Fits 2010, 2011, and 2012 GT500


555-3165$349.95
www.realspeedauto.com Ph.631-563-7325

All parts listed are for the Ford Mustang unless otherwise noted.

Copyright 2017 Realspeed Automotive Inc. All rights reserved.